Weather Stations

Adcon Telemetry


This extremely accurate sensor is made in Switzerland for Adcon and employs the same pressure sensor already in use in Adcon’s LEV1 water level sensor.

The piezoresitive sensor element is fully temperature compensated and performs with accuracy better than 0,1%FS across the whole range. According to WMO requirements the sensor itself is encapsulated in a robust polycarbonate housing, which will protect the sensor element from erroneous readings caused by wind gusts. A high-capacity Goretex vent makes sure that pressure inside the case equals outside pressure, and that water ingress is prevented.

The sensor box is mounted to the pole of a weather station by means of a mounting bracket and clamp supplied with the product. A shielded 2m cable with a 7-pin Binder jack connects the probe to any RTU of the A723, A733 and A75x product families.



Pressure range (FS) 500 … 1500mbar
Sensing element: piezoresistive pressure element
Accuracy: 0.1% FS
Operating temperature: -40°C … +100°C / -40°F … +212°F
Compensated temperature range: 0°C … +80°C / 32°F … +176°F
Supply Voltage: 3.5V … 12V DC
Output Signal: 0.1V … 2.5V
Material: Case: Polycarbonate

Sensor:Stainless Steel 316L (DIN 1.4435)

Dimensions LxWxH: 150 x 80 x 75mm / 5.9 x 3.15 x 2.95 in.including mounting bracket, goretex vent and gland nut
Weight: 330 grams (sensor only) / 0.73 lb.
Protection: IP67
Cable & Connector: 7-pin Binder jack with 2m cable

Have A Question About This Product?